hey jack tps help

[6-b-kwik]

hey jack have a tps question... car has a lil ruff idel and dont feel as strong open throttle! u think i should adjust it,,scanmaster reads key on tps.36then moves to .38 and very rare .40 when car off ?and when floored car off it reads 4.62 now car running i am seeing .38 and 3.100 to 3.900 floored 26psi 0.0 knock and 777 02's but fells like hesatation?thxs greg

[JCotton1]

Originally Posted by 6-b-kwik

hey jack have a tps question... car has a lil ruff idel and dont feel as strong open throttle! u think i should adjust it,,scanmaster reads key on tps.36then moves to .38 and very rare .40 when car off ?and when floored car off it reads 4.62 now car running i am seeing .38 and 3.100 to 3.900 floored 26psi 0.0 knock and 777 02's but fells like hesatation?thxs greg

Greg, can you give me a call at the shop.... I've been neglecting you, not on purpose, just been crazy here..... could be TPS is tasking a dump by all the fluxtuations, sp......

[6-b-kwik]

call u tomm

[6-b-kwik]

tried calling guess u were busy!!

what number shall i set tps at? still... n to the floor

[WSLN 6]

.40 key on/engine off should work fine, should be a tad higher once you start the car. Some chips do not like to see over .44 at idle.
WOT try and shoot for over 4.5 volts. You can test this right at the tps with a volt meter between the blue and black wires to see if the Scanmaster is accurate or not.

Sean Friesen

[JCotton1]

Originally Posted by WLN 6

.40 key on/engine off should work fine, should be a tad higher once you start the car. Some chips do not like to see over .44 at idle.
WOT try and shoot for over 4.5 volts. You can test this right at the tps with a volt meter between the blue and black wires to see if the Scanmaster is accurate or not.

Sean Friesen

Thanks Sean, ....