![]() |
|
Shop Work In Progress Up to date visuals of builds and repairs |
![]() |
|
Thread Tools | Display Modes |
#31
|
||||
|
||||
![]()
Awsome I love the shop, I could smell the gear oil all over again and my skin began to sweat...
![]()
__________________
Jack Cotton Cottons Performance 413-789-0531 |
#32
|
||||
|
||||
![]()
looks like you can walk around that shop without bumping into things
![]() ![]() |
#33
|
|||
|
|||
![]()
Jack/brian. I do not want my pan dropped or front cover removed yet.
I saw brians oil gauge at its lowest 20psi which rose respectively 10psi roughly each 1000rpm increase. I would like that gauge plumbed with a Brass tee at the sender port and the two compared in cockpit while driving. If the electric sender i installed is the culprit I would like an accurate mechanical gauge installed replacing it. I think the increase in oil pressue we saw with rpm drop was attributed from crank flutter ive seen in other engines. I want the car ASAP and may be back with my lowbed to get it. http://www.precisionengine.net/. Built the present engine. Originally leaving exhaust valve seals out. Simplex machine built the previous engine that ate its main bearrings in a week. *powerbasterds is the maker of the new alternator charging just over 12.5v i think the convertor is from PTC, billet 9" 3500 stall non l/u Combo; .40 over sealed power forged pistons, full throttle Revolution X Roller Cam Kit roller cam 210/215 .516/.516 110 L/S , 3 billet mains, ARP studs, P@P 445 heads, stainless valves, chromoly push rods, postons ceramic headers with ceramic crossover pipe, cottons performance downpipe with turbonetics external RG-45 wastegate and manual boost controller, single BB cpte66 .63 s-cover f1 wheel, mototron 60lbs injectors, AOD transmission transbrake/overdrive w/ 3500k billet NLU converter Last edited by brisbon; 11-14-2010 at 05:09 PM. |
#34
|
|||
|
|||
![]()
This is the outcome of that turbo race motor that lost oil pressure. Did everything myself as i have in the past since I ran outa cash.
IT... SCREWS. dart block patriot performance alumium heads eagle forged crank ibeam rods and forged pistons lumpy roller cam setup w scorpion rockers some heavy mods to get it to work.. p.s. have you sold my new fmic and fast system if not i want to pick it up asap. |
![]() |
Bookmarks |
|
|