|
|
|||||||
| Buick Turbo Tech General technical support for the 86-87 Buick turbo cars |
 |
|
|
Thread Tools | Display Modes |
|
#1
10-02-2008, 02:40 AM
|
||||
|
||||
cam setup
O.K guys,what cam kit would you guys recommend for my setup,im looking for a step up from stock with stock manners.i want to prevent any issues like having a wipe lobe.
__________________
210/210 DLS roller cam kit,2 1/2 hookers exhaust,test pipe,t49 turbo @ 20psi,42LB,billet adj fuel regulator,adj waste gate, tt chip,160 thermostat,hot wire kit,torque strap,boost&vac gauge,knock gauge,,billet aluminum vacuum block,17'' budnik wheels,Scanmaster,LT1 MAF,Translator,Vigilante 9 1/2 torque converter 2800 TO 3200 stall,trans cooler,Jimmy's rebuild trans,walbro fuel pump,PTE stock location ic,37,000plus miles and maybe alky to be a little slower 
|
|
#2
10-02-2008, 11:39 AM
|
||||
|
||||
|
Quote:
__________________
Jack Cotton Cottons Performance 413-789-0531
|
|
#3
10-02-2008, 10:53 PM
|
||||
|
||||
|
jack,the only thing thats been done to my gn is what in my SIGNATURE.
As far as having a problem with cam at this point no,no problems yet
__________________
210/210 DLS roller cam kit,2 1/2 hookers exhaust,test pipe,t49 turbo @ 20psi,42LB,billet adj fuel regulator,adj waste gate, tt chip,160 thermostat,hot wire kit,torque strap,boost&vac gauge,knock gauge,,billet aluminum vacuum block,17'' budnik wheels,Scanmaster,LT1 MAF,Translator,Vigilante 9 1/2 torque converter 2800 TO 3200 stall,trans cooler,Jimmy's rebuild trans,walbro fuel pump,PTE stock location ic,37,000plus miles and maybe alky to be a little slower
|
|
| Bookmarks |
|
|
Linear Mode
