|
|
|||||||
| Suspensions, Street and Strip This is where we talk about new and different suspension packages and what works best for your type of driving |
 |
|
|
Thread Tools | Display Modes |
|
#1
08-25-2008, 08:18 PM
|
||||
|
||||
M/T slicks
What compound are you using? Thanks
__________________
'86 Gn with an RPE bullet. Almost everything else is from Cottons. 100% street car! 
|
|
#2
08-28-2008, 06:24 AM
|
||||
|
||||
|
the 3055 28 x 10.5 that we use uses M5 compound, available with different sidewalls 3055 (std), 3055S (stiff ), and 3055W (wrinkle)
the 3055W due to the softer sidewall has a wider sidewall width 12.0" vs the 11.7" of the 3055/3055S the 3055C uses L4 compound ( softest compound they make) and is meant for dragsters and lightwieght cars im running the 3055 (stock frame and rolled fender lips, no air bags) which are a tight fit and only rub the frame when i make tight turns with a spool , probably more tire than i need . I'm considering going with 28x9" on the next set which come with the L8 compound , to read more on the differences in sidewall and compounds http://www.mickeythompsontires.com/s...p?item=ETDrag#
__________________
Paul... NJ rep MAGNABUICK.com the 86 3450lbs ...1.44 6.19@112 9.72@138 , 109 234cu stock mains and bolts , irons, the 87 ttop ,1.37 6.0@ 114 9.45 @ 141.9 25 psi !! 109 235cu .gn1 alum, certified roll cage . the 87gnx'd FAST B2B TA49 ..back to all stock original #s 109 and trans hipro w stagerite the 87 GN ttop ..all stock with vac brakes 86 WH1 mini tubbed roll caged 109, extreme 2004r all on pump 93 and alkycontrol Last edited by PaceCarTA; 08-28-2008 at 06:29 AM.
|
|
#3
08-29-2008, 12:55 PM
|
||||
|
||||
|
Thanks Paul. I ended up going with the 3055's and mounted them on a 8" wheel. I mounted them yesterday, and will install them on the GN today to test the fit. I also have some 3055's on 10" rims and I also rolled my fenders. They are tight (but look like they will clear). Last time at the track with the 10" rims w/o rolled fenders, I had to run 15psi in the air bags to keep them from kissing the fenders. I measured the section width of the 28-10.5 on the 8" wheel, and the section width is 1" less than on the 10" wheel with tread width remaining the same. I think this set up will be perfect, and I can leave the suspension where it should be.
__________________
'86 Gn with an RPE bullet. Almost everything else is from Cottons. 100% street car!
|
|
| Bookmarks |
|
|
Linear Mode
