Quote:
Originally Posted by PaceCarTA
had similar issue with hoopers car with the rear that he put in the #2
it had southside bars on it and the relocate brackets were welded in place , car would pull dead right at launch , uppers were stock , and he had an atr bar but replaced with an HR bar
i noticed one day that the tires werent even spaced in the wheel wells and after some quick measuring with a fist and some fingers it surely was off , big time ...three fingers on passenger side to rocker and a fist on drivers
the fix was he cut the welds loose with a whizzer wheel and used a ratchet straps to pull the rear into alignment measured carefully to points on the frame then rewelded the brackets
hes been going straight out of the hole since
|
Did he notice any difference in his 60' after he did that or did it just correct his launch?
__________________
87 GN, RPE built 109 stroked, RJC girdle, billet main caps, custom comp roller cam, Champion ported aluminum heads, Champion aluminum intake, T&D 1.65 rockers, 96 lb injectors, Accufab 70mm throttle body RJC pullies, RJC A/C bracket,GTK-850, ATR headers,Deeds electronic boost controller, Cotton’s 4 inch down pipe w/ Turbonetics RG 45 gate, XFI, Cotton’s front mount, Level 10 built 400 trans w/brake, Converter? ,33 spline Moser axles, Spool, HR bar.
New best 9.44 @ 143! 
|
09-24-2008, 03:12 PM
Threaded Mode