Some FAST questions

[turborambler]

I am newbie to the FAST stuff so not sure where to start.

I installed a FAST B2B that i bought used. It had a program in it for a buick 3.8 turbo -which is what i am running. I had to change the injectors to 55lb from 70 lb that where in the base setup in the ECU. The car will fire over and run for like 2 seconds then die. I can try to step on the gas pedal but it does not matter. It will die once it fires over and run for a sec. I have included what i think is a log file that may be usefull.

Here is some info on my car:

55 lbs Siemens Injectors
PT-51 Precision Turbo
wide band O2
Stock heads
5” single exhaust
3200 stall – turbo 400 tranny with manual valve body
3:73 gear with 28” tall tires
No a/c
No power steering
No power brakes
Running pump gas for now – sometimes use unleaded race fuel
Car weighs 3200 lbs with me in it
No VSS hooked up for now

The software is version 1.02 windows version of the software.

------------------------------------------------

The other question is where are the numbers and letters for the PIN out on the ECU? Do i need to pull the main harness off of the ECU and the numbers and letters will be there for each row? I want to make sure everything is hooked up right and i have a diagram but i have looked all over short of un-pluggin the harness and i can not see any letters or numbers to match up with my printout.

-----------------------------------------------

Thank You, Ross