|
|
|
|
#1
05-29-2013, 03:23 PM
|
|||
|
|||
head gasket
jack i think i blew my head gaskets what do you think i should use i think they were felpro gaskets. whats the best way to find out if the head gaskets are gone motors got less than 5000 miles on it,been sitting for about 6 years thanks for your help smoking bad when running david jacksonville fl
|
|
#2
06-04-2013, 07:26 PM
|
||||
|
||||
|
David,
The best way is to get a compression tester. Anyone with a Turbo Regal should have one. I think I have two. Anyway, that is your best way to test. If it is real bad, then you may be able to start the car, shut it down before it gets too hot and yank a plug and see some water/antifreeze on the plug. If it is smoking white real bad, and your antifreeze level is dropping then you probably have a bad head gasket. Also, check the oil for that horrible milk shake look.
__________________
Brian Keep it shiny side up, but show them your dirty side once in a while. 11.3@123mph on 195/75/14" whitewalls. Yes, 195s! 11.2 on the big giant slicks. What's the point? Maybe I'll go back to the whitewalls. They are lighter and have less rolling resistance.
|
|
#4
06-10-2013, 05:03 PM
|
||||
|
||||
|
Not a problem. I've been there before..........many many times.
It's not really that hard of a job in a Turbo Regal though. Good Luck.
__________________
Brian Keep it shiny side up, but show them your dirty side once in a while. 11.3@123mph on 195/75/14" whitewalls. Yes, 195s! 11.2 on the big giant slicks. What's the point? Maybe I'll go back to the whitewalls. They are lighter and have less rolling resistance.
|
 |
| Bookmarks |
|
|
Hybrid Mode
