[JCotton1]

1. remove line from master cylinder, closest line to the firewall.


2. Take supplied brake line and attach short side to the master cylinder

3. the other end goes into the brass straight fitting on the inlet side of the line lock solenoid. You may then attach the line lock where it sits on the fenderwell

4. carefully bend the original brake line to the outlet side of the line lock and attach, you can now bleed the line at that location. I usually have someone help bleed at this point.

5. now we can hook up our switch, attach one wire to ground, run the other wire to your switch and supply 12 volt power to the other side of your switch. You are done.. test it out and have fun..