i think i set the cam sensor right this is the second time it has gone out on me in a couple of years.And yes im using the casper cam tool to set it.i am using the original ac delco maf sensor that came with the car as a spare.it is a new part not used.
i also used a volt meter to check to make sure it was set properly.start out at 7 volt turn it alittle then volt meter reads 0.Some time tonight im going to start her up and disconnect to cam sensor to see what happens,and take her for a spin
__________________
210/210 DLS roller cam kit,2 1/2 hookers exhaust,test pipe,t49 turbo @ 20psi,42LB,billet adj fuel regulator,adj waste gate, tt chip,160 thermostat,hot wire kit,torque strap,boost&vac gauge,knock gauge,,billet aluminum vacuum block,17'' budnik wheels,Scanmaster,LT1 MAF,Translator,Vigilante 9 1/2 torque converter 2800 TO 3200 stall,trans cooler,Jimmy's rebuild trans,walbro fuel pump,PTE stock location ic,37,000plus miles
and maybe alky to be a little slower
Last edited by DA87GN; 08-14-2008 at 07:27 PM.
|