no need 4 a rebuild motor at this time
OK guys,i got great news.I dont need to rebuild the motor at this time .it appears that my 2 GM AC DELCO OEM MAF SENSOR where out of wack after
a couple of hundred mile on it.that was what was causing my gn to run like a turd.Evan with 17 psi just slow.did install my buddies LT1 maf sensor w translator and sh*t she came out of the hole smoking the tires just the way she use to be . i droped the oil pan and all is good their too.as far as the weird
noise that was coming from the engine bay,it was the cap to the cam sensor.ALSO INSTALLED A SCANMASTER TO BE ON THE SAFE SIDE TO KEEP A EYE ON THINKS
__________________
210/210 DLS roller cam kit,2 1/2 hookers exhaust,test pipe,t49 turbo @ 20psi,42LB,billet adj fuel regulator,adj waste gate, tt chip,160 thermostat,hot wire kit,torque strap,boost&vac gauge,knock gauge,,billet aluminum vacuum block,17'' budnik wheels,Scanmaster,LT1 MAF,Translator,Vigilante 9 1/2 torque converter 2800 TO 3200 stall,trans cooler,Jimmy's rebuild trans,walbro fuel pump,PTE stock location ic,37,000plus miles
and maybe alky to be a little slower
Last edited by DA87GN; 09-11-2008 at 01:58 AM.
|