View Single Post
  #16  
Old 09-10-2008, 02:59 PM
trbochrgd1's Avatar
trbochrgd1 trbochrgd1 is offline
I can't drive 55!
 
Join Date: Nov 2007
Location: North Jersey
Posts: 518
Default

Claude, thanks for the input! I was off when I drilled the bracket for the d/s. Now I don't think I have enough room to re-drill to make the bracket correct. The p/s side is good, d/s is not. The only way I could make it work with the HR bars is if I bought 1 1/2" longer one for the d/s. And is it a 1/2 longer than stock? Because the South Sides are longer than stock to begin with! AGHHHH!

Jack, can I bolt up those wolfe bars directly into my existing South Side brackets? That way I can measure the right side and make it identical to what it is now and adjust the d/s to where it is supposed to be, I think a 1/2 inch back.
__________________
87 GN, RPE built 109 stroked, RJC girdle, billet main caps, custom comp roller cam, Champion ported aluminum heads, Champion aluminum intake, T&D 1.65 rockers, 96 lb injectors, Accufab 70mm throttle body RJC pullies, RJC A/C bracket,GTK-850, ATR headers,Deeds electronic boost controller, Cotton’s 4 inch down pipe w/ Turbonetics RG 45 gate, XFI, Cotton’s front mount, Level 10 built 400 trans w/brake, Converter? ,33 spline Moser axles, Spool, HR bar.

New best 9.44 @ 143!
Reply With Quote