Quote:
Originally Posted by BrianHynes
What's up Brother? Haven't seen you around the board recently. Hope all is well in 'jersy.
|
Everything is good Brian, thank's for asking! We had a big police/security expo in A/C that we have been getting ready for and I just got back home now. Just have a lot of stuff going on between the kids and work, you know what I mean!
Have you run your car yet? Any pics of the cage?
Quote:
Originally Posted by PaceCarTA
he was at etown last friday night , car was running very well, surprised he didn't post up the slips and the video ,his last round was scary
btw mike if you were wondering about the cause of the squirrelly run on the last round , i was right behind you and logs showed i lost traction after the launch as well , my guess is someone dropped some fluid (brake fluid ) on the left side causing the car to dart left
|
Thanks Pauly, I haven't had a chance to load up the video on you-tube yet, or post up any times.
I had 4 runs at e-town, first run was off, totally my fault, 10.63 @134.79, but my next pass was 9.48 @142.37 with a 1.44 60'. After that I ran 9.44 @143.12, 1.39 60'. Last pass as Pauly said was a little scary, my powermaster started leaking pretty bad, on the d/s side and I have a trans fluid leak on the p/s side! I almost tagged the 330 cone!
I ran 9.76 @138.39, 1.40 60', on that one, I think I made the 1/4 twice as long on that one going back and forth! Yikes! Did I run in left lane too.?
All in all it was a good night. It was great to see Pauly again. His car is beautiful and it rips!
My car ran its best of 9.44 @143. Everything else is ok, besides the leaks, drove it back in the trailer, and now it's time to get the 60' down, change the master over to a manual one and fix the trans leak.
__________________
87 GN, RPE built 109 stroked, RJC girdle, billet main caps, custom comp roller cam, Champion ported aluminum heads, Champion aluminum intake, T&D 1.65 rockers, 96 lb injectors, Accufab 70mm throttle body RJC pullies, RJC A/C bracket,GTK-850, ATR headers,Deeds electronic boost controller, Cotton’s 4 inch down pipe w/ Turbonetics RG 45 gate, XFI, Cotton’s front mount, Level 10 built 400 trans w/brake,
Converter? ,33 spline Moser axles, Spool, HR bar.
New best 9.44 @ 143!