Downpipe!
 

Jack, I talked to you a couple of months ago about sending my turbo and headers to get Brian to make a downpipe for me. Is now a good time to send them? I need a 3.5 in with provision for external gate. I could have called, but thought I would make use of the new site.

:)

Ok, not sure who this is, could you sign a signature. Thanks for using the site, in the end it is the best place to get me, not to mention it documents things for me since I can't remember chit... :) I ordered more pipe, hope to have it in a few weeks. These damn things are getting more expensive everytime I get in fresh metals....

This is Sharif from Chapel Hill NC. I bought some Champion aluminums, scorpion roller rockers, roller cam kit, and Baer brake setup from you. It has been a couple months since we have spoken on the phone. The last time we spoke, I mentioned that I need to get a downpipe made and you said that you needed a couple of weeks to get cleared up and that I should call before sending my turbo and headers to you. Anyways, let me know when is good for you and I'll get those parts to you. I'll update my sig also.

Ok, thanks Sharif..... too many calls to remeber who's who... :) Check with me in about 2 weeks, I should be able to get you going. Need to have you ready before Cecil County.

Sharif,
Chapel Hill! Are you a member of GM_Turbo6@yahoogroups.com? It is a loose-knit group of TR owners in North Carolina. Give me a call at 704-983-2302.
Conrad Carter
Albemarle, NC

I am not a member, but I will check it out. Did I meet you at one of the Jordan Lake gatherings? Anyway, Jack are you ready for me to ship my headers and turbo to get that downpipe made?

Almost there.... we have 2 here now to do. Waiting on some material as I type..

:D:D
________
How To Roll A Joint

Cool. Just let me know.

The down pipe will be worth the wait:)
Ask me how I know. My Kenne Bell headers and cross over fianlly fit correctly, thanks to Brian.