Jack Can It Do It
 

--------------------------------------------------------------------------------

Stock 109 Block .030 Over
Forged Pistons
Total Seal Rings
Stock Crank
Stock Rods With Arp Bolts
All 4 Billit Mains
Commetic Head Gaskets
Champion Gn1-r Heads
Arp Studs
62 Mm Tb
62 Mm Dog House
Rjc Plate
Comp Roller Cam 212
T&d Roller 1.55 Rockers
High Volume Front Cover
6169e Turbo
2 1/2 Exaust With Cut Out
3" Th Downpipe
60lb Injectors
160 Stat
Adj Fpr
340 Walbro
23 Row Intercooler
Razors Alky
Tt Chip
3400 Pats Conv Lock Up
Umi Control Arms
H&r Rear Sway Bar
Duel Air Bags
What Am I Missing? Need Imput Looking To Run 10.5's
are the injectors gonna be enough?
turbo?
Also do you think that the champion gn1 intake is needed or stay with a stock ported one? then tb size?

Nice combo, but your turbo and injectors will be the limiting factors.

Wat Do You Think 85 Lbs And A 6776 Ball Bearing?

I concur.. :)

You would need a minimum of 60lb injectors, and probably a CPT66-65BB or a 67 turbo. Now the injector size and the fuel pump will work as long as you use alky or meth, otherwise the injecters and fuel pump will be struggling to reach 10.50et. I would also recommend a volt booster to get all you can out of the fuel pump. There are several other areas I might upgrade, but what you have should get you there...

is the champion gn1 intake needed or a ported stock unit?

I have been 133mph on a bb70 with ported stock intake and ported stock heads in my fat 3700lb car. A Champion ported one would give you nice peice of mind though.....