DA87GN
08-28-2009, 11:09 PM
Whats up Jack,my question is 3 weeks ago i ended up going to the track and was able to make 4 passes this time with my drag radials.The 1st,2nd and last pass was done on over drive and the 3rd was on drive.I notice that i was hitting the rev limiter very close to the finish line when i was in drive but not in over drive.All number from my scanaster looked fine,i was wondering if my new build tranny/conv was causing this to happen.
By the way the builder of my tranny was Jimmy the guy that all of us chicago boys use
pretty much all the runs were all the same with 5psi off the line and 23 down the track
12.17 @111mph
12.28 @111mph
12.17 @109mph
12.09 @112mph
To me the tranny felt alittle lazy going into 3rd:mad:
By the way the builder of my tranny was Jimmy the guy that all of us chicago boys use
pretty much all the runs were all the same with 5psi off the line and 23 down the track
12.17 @111mph
12.28 @111mph
12.17 @109mph
12.09 @112mph
To me the tranny felt alittle lazy going into 3rd:mad: